SEKURE DGP2-648 Instrukcja Instalacji Pobierz pdf (Strona 24)

22 REFERENCE & INSTALLATION MANUAL

7.5.1 Tamper Bypass Options

SECTION [3034]: OPTION [7]

(Default = enabled) With option [7] enabled in section [3034], the control

panel will ignore the zone’s bypass definition and will follow the option set in

section 7.5 if a tamper or wire fault occurs on a bypassed zone. With option

[7] disabled, Tamper Recognition follows the zone’s bypass definition. This

means that the control panel will not perform any action if a tamper or wire

fault occurs on a bypassed zone.

7.6 KEYPAD PANIC OPTIONS

(Default = disabled) The control panel can generate an alarm (audible, fire

or report only) by pressing the keypad Panic key(s). For LCD keypads, two

keys are pressed and held simultaneously for 2 seconds. For Grafica

keypads, the appropriate Panic key is pressed and held for 2 seconds.

Refer to the table below for the keypad Panic keys. In the section that

corresponds to the desired partition, enable or disable options [1] through

[6] as desired:

REPORT ONLY

The keypad emits a single Confirmation Beep and transmits the appropriate

report code (see section 8.2.10).

AUDIBLE ALARM

The control panel activates the BELL output until a user cancels the alarm

with a valid User Access Code or when the Bell Cut-Off Timer elapses (see

section 7.2).

FIRE ALARM

Same as audible operation, except that the bell/siren output will be pulsed

as shown in Figure 4-4 on page 14.

* UL Note: For UL Listed systems, all emergency non-medical and auxiliary

panic alarms shall be report only.

Partition 1: [3123] Partition 3: [3323] Partition 5: [3523] Partition 7: [3723]

Partition 2: [3223] Partition 4: [3423] Partition 6: [3623] Partition 8: [3823]

Option Feature Press and Hold:

[1] Panic 1*

LCD keypads: Keys [1] and [3] simultaneously

Grafica keypads: The key

[2] Panic 2*

LCD keypads: Keys [4] and [6] simultaneously

Grafica keypads: The key

[3] Panic 3

LCD keypads: Keys [7] and [9] simultaneously

Grafica keypads: The key

Option Alarm Type

[4] Panic 1:*

ON = Audible

OFF = Report Only

[5] Panic 2:*

ON = Audible

OFF = Report Only

[6] Panic 3:

ON = Fire

OFF = Report Only

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 63 64

Komentarze do niniejszej Instrukcji

Brak uwag

SEKURE DGP2-648 Instrukcja Instalacji Strona 24

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa SEKURE DGP2-648