SEKURE SX-3100LCD Instrukcja Operatora Pobierz pdf (Strona 351)

GAS ANALYZER 339

SNAPSHOT MODE

The snapshot function is used to support use of the Gas Analyzer during road-test

operation or to capture intermittent problems. Snapshot collects Gas Analyzer and, if

selected, vehicle data for later analysis. Snapshot durations of up to ten minutes are

supported.

Manual Snapshot

Press 2 to select the <MANUAL SNAPSHOT> mode from the <GAS ANALYZER>

menu. Press the e key to trigger the snapshot and begin capturing data.

Data Capture Phase

The Line Graph screen appears. Use the l and r keys to select the desired time scale for

the snapshot before trigger. Use the u and d keys to select a data parameter. <WAIT:

MANUAL TRIGGER> is displayed at the bottom of the screen until the snapshot is

triggered. When a trigger occurs, <TRIGGER> is displayed at the bottom of the screen

while data is being saved.

ACTIVE KEYS

l r Select snapshot capture time scale. Allowable time scales are 60, 100, 240,

300, and 600 seconds (<LINE GRAPH> mode only).

u d Move the display up or down one parameter.

Au Move the display one page (<DATA LIST> mode only).

y Change the highlighted parameter to the next parameter in the list. (<LED/

LIST>, <BAR GRAPH>, and <LINE GRAPH> modes only.)

n Change the highlighted parameter to the previous parameter in the list.

(<LED/LIST>, <BAR GRAPH>, and <LINE GRAPH> modes only.)

e Triggers the snapshot and terminate data capture.

! Go to <DATA LIST> mode.

@ Go to <LED/LIST> mode.

# Go to <BAR GRAPH> mode.

$ Go to <LINE GRAPH> mode.

( Change between large and compressed character size.

) Turn cursor on and off.

Ah Display parameter information.

s Print data list.

NOTE

Do not operate the keyboard while the Tester is saving vehicle

data.

1 2 ... 346 347 348 349 350 351 352 353 354 355 356 ... 377 378

Brak uwag

SEKURE SX-3100LCD Instrukcja Operatora Strona 351