SEKURE SX-3100LCD Instrukcja Operatora Pobierz pdf (Strona 254)

242 BREAK-OUT BOX

9.0 BREAK-OUT BOX BATTERY

CHARGING AND REPLACEMENT

The Break-out Box contains a rechargeable nickel-cadmium (NiCad) battery pack.

NICAD BATTERY PACK

The NiCad batteries are housed in a removable battery pack located in the upper part of

the Break-out Box cover. For normal use the Break-out Box should be powered from the

vehicle’s cigarette lighter or battery adapter cable. However, on some vehicles power is

not available at the cigarette lighter when the ignition is off or when the engine is

cranking. The NiCad battery pack provides power to the Break-out Box under these

conditions. When fully charged, the battery pack can power the Break-out Box for up to

one hour.

POWER SOURCE WARNING DISPLAY

If the screen on the left is displayed, the external power cable should be connected. If the

power cable is disconnected, the measured data will not be accurate.

The power cable is always needed to connect to the vehicle’s battery via the Battery

Adapter Cable or the cigarette lighter.

CHARGING THE BATTERY PACK

The Break-out Box constantly charges the NiCad battery pack as long as it is connected to

a 12 VDC power source. In normal use the Break-out Box will keep the battery pack

adequately charged. However, if the Break-out Box is used for extended periods of time

with the vehicle ignition off, or stored for an extended period of time without use, the

NiCad battery pack may become discharged.

To recharge the battery pack, connect the Tester and Break-out Box to a 12 VDC power

source such as the vehicle battery or the 12-volt AC/DC power supply, and turn the Tester

and Break-out Box on. It takes approximately 1 hour to fully recharge the battery pack.

Remember, the battery pack is required only when power is not available at the cigarette

lighter socket. If the battery pack is not charged and you need to use the Break-out Box,

simply connect the Break-out Box directly to the vehicle’s battery with the Battery

Adapter Cable and cigarette lighter DC power cable supplied with the Tester kit. This

allows operation of all diagnostic procedures with the Break-out Box and starts recharging

the battery pack at the same time.

NOTE

Always turn the Tester off when not in use!

HINT

If the data is difficult to read due to the flashing display, use the

snapshot mode to capture data, then review the data after the

battery is charged.

FIGURE 1 POWER SOURCE

WARNING DISPLAY

1 2 ... 249 250 251 252 253 254 255 256 257 258 259 ... 377 378

Brak uwag

SEKURE SX-3100LCD Instrukcja Operatora Strona 254