SEKURE Paradox Digiplex DGP-610 Instrukcja Instalacji Pobierz pdf (Strona 16)

- 15 -

ZONE PROGRAMMING

All detection devices, whether connected to the control panel, keypads or zone expander modules must be

assigned to a zone and that zone must be defined as described in this section:

• Serial # of the Device/Module

• Input # of the Device/Module

• Zone Definition

• Zone Partition Assignment

• Zone Options

The Zone Numbering feature enables you to individually assign each detection device to any desired zone in the

Digiplex system. Please refer to section 5.1 of this manual for details. The Zone Parameters define the type of zone, the

zone’s partition assignment and how the control panel will react when an alarm condition occurs on that zone (see

sections 5.2 to 5.4). For more information on the installation of devices and modules, please refer to section 2 of this

manual.

Press & hold the

[0] key

Zone Definition

First Digit

Zone Partition

Assignment

Second Digit

Zone Options

Feature Select

Enter 8-digit

[SERIAL NUMBER] of the bus

detection device or of the

module to which a hardwire

device is connected

Enter 3-digit [INPUT NUMBER ] of

module to which device is

connected

NOTE: For motion detectors and

keypads no input # is required

Key-in

[INSTALLER CODE]

Zone Definitions

0- Disabled 6- Instant

1- Entry Delay 1 7- 24Hr Buzzer

2- Entry Delay 2 8- 24Hr Burglary

3- Entry Delay 3 9- Delayed 24Hr Fire

4- Entry Delay 4 A- Stand. 24Hr Fire

5- Follow

Zone Partition Assignment

1- Zone Assigned to Partition 1

2- Zone Assigned to Partition 2

3- Zone Assigned to Partition 3

4- Zone Assigned to Partition 4

Zone Options

[1] Auto Zone Shutdown

[2] Bypass Zone

[3] Stay Zone

[4] Force Zone

[5] [6] Zone Alarm Type

off off Audible Alarm (steady)

off on Audible Alarm (pulsed)

on off Silent Alarm

on on Generates only a report

[7] Intellizone

[8] Delay before transmission

Press [ENTER ]

Figure 5.1 - Zone Programming

Key in 3-digit

[SECTION ]

Select one only

Zone Parameters

Sections [101] to [148] represent

zones 1 to 48 respectively

Select

only one

Zone Numbering

Sections [001] to [048] represent

zones 1 to 48 respectively

Select one

or more

}

Zone Parameters

[101] to [148]

}

Zone Numbering

[001] to [048]

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 53 54

Komentarze do niniejszej Instrukcji

Brak uwag

SEKURE Paradox Digiplex DGP-610 Instrukcja Instalacji Strona 16

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa SEKURE Paradox Digiplex DGP-610